Belden Hirschmann RED25 Series, Руководство пользователя

Страница: 24 / 40

24
Installation RED25
Release 01 02/2015
Proceed as follows:

Remove the protective cap from the SFP transceiver.

Push the SFP transceiver with the lock closed into the socket until you
hear it latch in.
2.4 Connecting the power supply and signal
lines
WARNING
ELECTRIC SHOCK
Never insert pointed objects (narrow screwdrivers, wires, etc.) into the
device or into the connection terminals for electric conductors. Do not touch
the connection terminals.
Before connecting the electrical conductors,
always verify that all of the
requirements listed are fulfilled:
See “Requirements for connecting electrical conductors” on page 6.
Failure to follow these instructions can result in death, serious injury,
or equipment damage.
1 Power supply connection 1
1a
24 V
1b 0 V
2 Connection for the signal contact
3 Power supply connection 2
3a
0 V
3b 24 V
Table 10: Pin assignment: 6 pin, screwable terminal block (on the top), connection
to the device (at the bottom)
1a 1b 2 2 3a 3b