Configuration
4.12 L2TP Tunnel Configuration
4.12 L2TP Tunnel Configuration
L2TP is an unencrypted protocol. L2TP via IPv6 is not supported.
To open the
L2TP Tunnel Configuration
page, click
L2TP
in the
Configuration
section of the
main menu. The L2TP tunnel function allows you to create a password protected connection
between 2 LAN networks. Enable the
Create L2TP tunnel
checkbox to activate the tunnel.
Item
Description
Mode
Specifies the L2TP tunnel mode on the router side:
•
L2TP server
– Specify an IP address range offered by
the server.
•
L2TP client
– Specify the IP address of the server.
Server IP Address
IP address of the server.
Client Start IP Address
IP address to start with in the address range. The range is
offered by the server to the clients.
Client End IP Address
The last IP address in the address range. The range is offered
by the server to the clients.
Local IP Address
IP address of the local side of the tunnel.
Remote IP Address
IP address of the remote side of the tunnel.
Remote Subnet
Address of the network behind the remote side of the tunnel.
Remote Subnet Mask
The mask of the network behind the remote side of the tunnel.
Username
Username for the L2TP tunnel login.
Password
Password for the L2TP tunnel login. Enter valid characters only,
see chap.
Table 39: L2TP Tunnel Configuration
Figure 41: L2TP Tunnel Configuration
UM Configuration OWL LTE M12
Rel. 06.1.09 - 07/2019
85
