Belden Hirschmann MICE MS20, Руководство пользователя

Страница: 46 / 82

46
Installation MS20/MS30
Release 13 09/2019
2.4 Installing an SFP transceiver (optional)
Use only Hirschmann SFP transceivers which are suitable for usage with the
device.
See “Accessories” on page 77.
Proceed as follows:

Remove the protection cap from the SFP transceiver.

Push the transceiver with the lock closed into the slot until it latches in.
2.5 Adjusting the DIP switch settings on the
basic module (4-pin DIP switch)
The 4-pin DIP switch on the bottom panel of the basic module provides you
with the following options:
DIP switch Function Delivery state
RM (redundancy
manager)
a
a. You use the “RM” and “Stand-by” switches on the 4-pin DIP switch to switch the following
functions on and off (see table 6)
With the HIPER-Ring function switched
on, switch the RM (Redundancy Manager)
function on and off (see “User Manual
Redundancy Configuration”). OFF position (RM function
deactivated)
Ring port
b
b. Using the “Ring port” switch on the 4-pin DIP switch you select the ring ports for the HIPER-
Ring (see table 5)
Selection of the ports for the HIPER-Ring
MS30: In the ON position, ports 1 and 2 in
module 2 are for connecting the HIPER-
Ring.
MS20: In the ON position, port 1 from
modules 1 and 2 are for connecting the
HIPER-Ring. OFF position (ports 1 and 2 in
module 1 form the connection
for the HIPER-Ring).
Stand-by
a
With the redundant coupling of rings, you
assign the redundancy function to the
MICE in the redundant line (see “User
Manual Redundancy Configuration”). OFF position (normal function)
SW Configuration /
DIP Configuration OFF: Give the software configuration
precedence over the DIP switch position.
In this case, the other switch positions are
meaningless. OFF position (SW configuration
has precedence)