Belden Hirschmann MACH104-16TX-PoEP Series, Руководство пользователя, Страница: 27 / 48

Installation MACH104-PoEP
Release 06 11/2013
27
Note: The shielding ground of the connectable industrial twisted pair lines is
connected to the front panel as a conductor.
2.5.2 Mounting on a flat surface
Before operating the device on a flat surface, such as a table, fasten the
housing feet supplied at a distance of 2 cm from the corners of the bottom of
the device.

If necessary, remove any dirt from the adhesive surfaces on the bottom
of the device.

Remove the protective foil from the adhesive surface of a housing foot
and attach the housing foot.
2.5.3 Mounting in a switch cabinet
Note: Install the device in the 19" switch cabinet using sliding or mounting
rails.
This provides a more stable position of your device in environments subject
to vibration.
For more information on sliding/mounting rails and how to install them,
please contact your switch cabinet manufacturer.
The devices are designed to be mounted in a 19" switch cabinet.

Make sure there is sufficient ventilation. If necessary, provide a fan for the
19" switch cabinet. This will prevent the basic devices from overheating.

Measure the depth of the 19" switch cabinet so as to allow the power
supply cables to be fitted at the back and the data cables to be fitted at
the front.

Install the sliding/mounting rails in the 19" switch cabinet as instructed by
the manufacturer, and make sure the device is resting on both rails.