7: Administration
UM Configuration BAT-C2
140
Release 01.0.00 04/2019
Note:
The system log is saved to local storage but is not retained through reboots. To
allow the administrator to save the complete system log, save the system log to a server
that supports remote logging services. For details, refer to RFC 3164. The default port is
514.
To Configure Syslog Settings
Using Web Manager
1. In the Web Manager, click the
Administration
tab.
2. Click
Syslog
.
3. To enable Syslog, for
State
, select
Enabled
.
4. For
Host
, type the IP address of the remote server that stores the logs.
5. For
Remote Port
, enter the port number for the remote host that supports logging services.
The default port number is 514.
6. For Local Port, enter the local port number.
7. For
Severity Log Level
, click the arrow to select the minimum level message type that you
want the system to log.
8. Click
Submit
.
Using XML
Include in your file:
<configgroup name="syslog">
System
The BAT-C2 settings allow for reboot, restoring factory defaults, uploading new firmware and
updating a system’s short and long name.
Note:
Anytime you reboot the unit, this operation will take some time to complete.
Please wait a minimum of 10-20 seconds after rebooting the unit before attempting to
make any subsequent connections.
System Settings
Description
State
Select to enable or disable the reboot schedule. Disabled by default.
Notice: The BAT-C2 will automatically reboot as scheduled. Please note
that any configuration changes not saved to flash memory will be lost.
WEB sessions and network traffic will be interrupted. To avoid frequent
reboots, BAT-C2 will not be rebooted if it was started or configured less
than 30 minutes from the current date/time.
Schedule
Select the reboot schedule interval: Daily or Interval (default is Daily).
Time (24 hour)
Set the time to reboot by selecting the Hour and Min (Minute) in the drop-down
menus.
Note:
This configuration option appears when the
Daily
schedule is selected.
Table 7-26 System Settings