GUIDE TO INSTALLATION AND OPERATION
10
| MDX-3901
Step 2: To install the MDX-3901 Card:
Once a matching rear connector panel has been installed, install the MDX-3901 card as follows:
1. Open the front panel of the frame.
2. Slide the MDX-3901 card into the slot and push gently on the handle to seat the connectors.
When using a double-slot-width rear panel, the card should be inserted into the right-most of the two slots.
Inserting the card into the wrong slot will not damage the card, and will be flagged by the on-card status LED
flashing red to indicate that there is no connection to the rear panel.
3. Close the front panel of the frame.
2.2 Installation of the Optical Interface (option)
– Installing the Optical Interface
2.3 Rear Panels and Connectors
2.3.1 Images of Rear Panel Connectors
The four available rear panels are shown in the figure below, and their various inputs and outputs are described.
Figure 2.2
MDX-3901 Rear Panels (left to right): MDX-3901-7-3+SRP-Q, MDX-3901-1-3+SRP-Q,
MDX-3901-7-3DP-Q-F, and MDX-3901-1-3DP-Q-F
