Belden Grass Valley Kayenne K-Frame, Инструкция по установке и обслуживанию

Страница: 233 / 288

KAYENNE K-FRAME — Installation & Service Manual 233
Touchscreen Calibration
tion Module) fails due to a multi-pin cable problem. That essential ME
Stripe can be re-assigned to a different PCU port that has an operational
multi-pin cable, restoring Kayenne Control Panel operation.
To remap ME Stripes, on any Transition Module press the three right-most
buttons over the Lever Arm at the same time to enter ME Stripe Mapping
mode.
Figure 158. Button Hold Down for ME Stripe Mapping
On the ME Stripe you wish to remap, press a
Key 1
through
Key 6
button on
the Transition Module in that Stripe to choose a PCU port for that Stripe. If
that PCU port is used by another Stripe, it will be swapped.
When the Stripes are remapped, press the button labeled EXIT (
Key Prior
).
The display informs you that mapping changes take place after reboot, and
a with a Reboot Now prompt appears. Pressing the button labeled YES will
reboot the Panel.
Touchscreen Calibration
The Kayenne Touch Screen Menu Panel is adjusted in the factory before
shipment, and so should not require calibration. If the Menu Panel does not
respond correctly to screen touches, however, you can perform this proce-
dure.
1. Minimize
or
Exit
the Kayenne Menu application.
2. With the Windows desktop visible, click on
Start
/
Programs
/
Hampshire
TSHARC Control Panel
. The Hampshire application will open.
Mix Trans ns
PVW
Trans ans
Rate
EMEM EMEM
Run un
Ptn tn
Lim Limit
Pst
BLK
Key Key
1
Key Key
2
Key Key
3
Key Key
4
Key Key
5
Key Key
6
Ke Key 1
Cut Cut
Ke Key 2
Cut Cut
Ke Key 4
Cut Cut
Ke Key 3
Cut Cut
Ke Key 6
Cut Cut
Ke Key 5
Cut Cut
Ke Key 1
Auto Auto
Ke Key 2
Auto Auto
Ke Key 3
Auto Auto
Ke Key 4
Auto Auto
Ke Key 6
Auto Auto
Cut Cut Auto Auto
Ke Key 5
Auto Auto
User er
5
User er
6
User er
4
Wipe ipe
2
Wipe ipe
1
User er
3
User er
2
User er
1
Key
Prior
1. 1.
8623266_70
U S E K 1 T H R U K 4 B U T T O N S
T O S E T M E S T R I P E N U M B E R .
S T R I P E 1 I S T O P O F P A N E L
M E S T R I P E = 1 P C U P O R T = 1
E X I T
i DPM DPM i DPM DPM i DPM DPM i DPM DPM i DPM DPM i DPM DPM