Belden Grass Valley Kayenne K-Frame, Инструкция по установке и обслуживанию

Страница: 232 / 288

232 KAYENNE K-FRAME — Installation & Service Manual
— Maintenance
3. Follow the instructions displayed, rotating the Joystick and pressing
the bottom right button labeled
NEXT
.
Result:
The
NEXT
button label changes to
END
.
Press the
END
button to complete the calibration and return the module to
its Home state.
Figure 157. Button Hold Down for Joystick Calibration
Calibration settings are saved with the module. Disconnecting, recon-
necting, or moving the module to a different location on the Control Panel
(including a different Stripe) should not affect the calibration for that
module.
ME Stripe Mapping
The recommended PCU port to Stripe multi-pin cable connection order
uses the following conventions:
• Lowest PCU Port > Top ME Stripe (under Local Aux Stripe if present)
• Next PCU Port > Next lower ME Stripes in order
• Highest contiguous PCU Port > Local Aux Stripe
• Stripes in the same Suite should use contiguous PCU ports.
By following these cabling conventions, troubleshooting will be easier
because the connections will be consistent.
It is possible to re-map ME Stripe to PCU port connections. This can be
useful if an essential ME Stripe (for example, the one with the Multi-Func-
Wipe ipe
1
Key Key
5
Key Key
3
Key Key
1
Wipe ipe
2
Key Key
6
Key Key
4
Key Key
2
M o v e t h e J o y s t i c k t o b o t t o m
r i g h t a n d r o t a t e t h e Z - A x i s t o
t h e r i g h t a n d p r e s s N E X T b u t t o n .
C a l i b r a t i o n
NEXT
HOME
8623266_69