Belden Grass Valley Kayenne K-Frame, Инструкция по установке и обслуживанию

Страница: 226 / 288

226 KAYENNE K-FRAME — Installation & Service Manual
Section 6 — External Interfaces
Touch
Eng Setup
,
Router
selection button to go to this menu.
Figure 152. Eng Setup Router Menu
The
Status
indicator is red when communication is not detected, and goes
green when communication is established.
To Set the IP Addresses:
1. Touch the
Primary IP
data pad and enter the primary address of the
router with the pop-up keypad.
2. Touch the
Secondary IP
data pad and enter the secondary IP address of
the router, if appropriate. If the router has only one control system,
leave this address set to the blank default.
Note If the K-Frame system has been configured with a router IP address but a
connection to the router has not been established, changing the IP address
in this menu will not make the K-Frame system immediately try to connect to
the new router address. The K-Frame system will automatically try to connect
after about 30 seconds using the entered router IP addresses.
Primary and Secondary Router Communications
The Kayenne K-Frame system will initially use the primary router IP
address for communications. If the primary control system fails to respond,
the system will attempt to use the secondary IP address for router commu-