Belden Grass Valley Kayenne K-Frame, Инструкция по установке и обслуживанию

Страница: 151 / 288

KAYENNE K-FRAME — Installation & Service Manual 151
Ethernet Tally Configuration
2. Select the
MV Tally
button in the Tally System pane (upper right).
3.
Select one of the four Tally Calc tabs.
4. Select the Calc Name data button and enter a descriptive name for the
calculation;
LAP 1
for Look Ahead Preview in Suite 1 as an example.
5. Assign tributaries to the four Look Ahead Previews:
a. Select
LAP 1
then
Tributary 4
,
b.
Select
LAP2
then
Tributary 3
, and so on.
6. Turn on the calculation by selecting the
Calc On
button (highlights green
when on).
7. Select the
MV Tally
tab.
8.
Select the LAP configured tally calculation; for example
Calc 1 LAP 1
.
Ethernet Tally Configuration
The GV Switcher system provides all the tally data needed by the Ethernet
tally client. Typically, the only user-defined selection for Ethernet tally from
the switcher is the on-air Program ME. PGM/PST is the default on-air tally
Program ME, however any licensed ME can be defined as Program.
Sources are on or off air based on the Program ME selection.
Configure the On-Air Tally Program ME
The default on-air Program ME is PGM/PST.
1. Select
Eng Setup
,
Switcher Tally
,
On Air Tally
.
2. Select an available (licensed) ME as the on-air tally Program ME, for
example ME 1, ME 2, Aux, etc.
Configure the GV Switcher Ethernet Tally System Interface
The GV Switcher system must be configured to interface with third party
Ethernet Tally systems. An initial tally client port selection can help ensure
a successful connection.
1. Configure the Ethernet Tally interface IP Address:
a. In the Eng Setup, Ports & Devices menu, select the
Tally Ports
tab.