Belden Grass Valley Kaleido-X, Инструкция по установке и обслуживанию

Страница: 24 / 216

24
Installation
Optional Ancillary Equipment
In addition to the above, you will need the following (not supplied):
• Up to 12 displays
• A dedicated 100Base-T Ethernet switch with enough ports for the Kaleido-X, client PCs,
Kaleido-RCP2, and Audio Bridge Terminals
• Client PC (see System Requirements for a Client PC , on page 101)
• Cables (to connect your multiviewer to video sources, to displays, and to the network):
Optional Ancillary Equipment
The following optional equipment may be supplied with your order.
• Kaleido RCP-2 or RCP-200 multi-function remote control panel
• Audio Bridge Terminal (ABT)
KX0-24Router Card Overview
The KXO-24Router card provides 24 external monitoring outputs that can be assigned to
any of the 96 HD/SD SDI inputs of the Kaleido-X. Two cards can be installed in a Kaleido-X to
provide up to 48 outputs. These unprocessed outputs can be used to feed high-quality CRT
monitors, test equipment such as waveform monitors, as well as master control or
production switchers.
Signals of same format are switched in the vertical interval to avoid glitches. The sync
reference used for switching the output signals on the router card is derived from the
GPI/genlock card. If no reference is present on the GPI/genlock card, the sync reference is
derived from the signal connected to Input 1 of the KXI-16 card installed in slot 4, i.e. the
leftmost KXI-16 card as seen from the front of the frame.
Cable type Purpose
CAT-5 For Ethernet connectivity
Display cables Either extension modules—for example, Grass Valley’s DXF-200 (part
number DXF-200-A)—or DVI cables
Video cables Standard coaxial cables with BNC connectors
Note:
On all Kaleido multiviewers, the network adapters are set to auto-
negotiate. By default, the connection speed and duplex mode will be set
automatically based on the corresponding port settings on the switch.