Belden Grass Valley Kaleido-X, Инструкция по установке и обслуживанию

Страница: 171 / 216

171
Kaleido-X (7RU)
Installation & Service Manual
Upgrading the Multiviewer Using a USB Key
See Kaleido Software Minimum Version Compatibility , on page 18 for the Kaleido Software
compatibility with your current hardware and to identify if any required hardware upgrade
may be necessary to be done before you upgrade your multiviewer.
IMPORTANT
Before upgrading the multiviewer system, review the following.
Kaleido-X may require new CompactFlash storage cards
As of version 8 of the Kaleido Software, every KXO-Dual3 output card in a
Kaleido-X multiviewer must have a 4 GB CompactFlash storage card on
board. Output cards with a 2 GB CF card cannot be upgraded to version 8 (or
later). Contact Grass Valley to order the 4 GB CF cards you need (see
Grass
Valley Technical Support , on page 216).
Upgrading from a version prior to 6.60
Version 6.60 of the Kaleido Software introduced a change in the alarm
debouncing calibrations, which could result in alarms being raised earlier
and more frequently, after upgrading. The following properties have been
removed from the list of configurable parameters:
Occurrences and
Detection window . After the upgrade, the system behavior will be based on
1 occurrence of an alarm event. A detection window is no longer used.
If, prior to the upgrade, the Occurrences parameter was set to a value other
than 1, then you will need to revise the Set duration value after the upgrade
to take this change into account. For example:
•
Before the upgrade — If you had the following settings: Occurrences = 3,
Duration = 5 seconds, before the upgrade, then an alarm would be raised
after 15 seconds.
• After the upgrade — The former settings will be replaced with the
following: Set duration = 5 seconds, and the alarm will be raised after 5
seconds.
In this example, after the upgrade, you should set the Set duration
parameter to 15 seconds to maintain the same behavior.
It is recommended to review and note down the alarm debouncing
calibrations prior to the update, and to re-calibrate the alarm debouncing as
needed after the upgrade.
Upgrading a Kaleido Software multiviewer with KXO-HDM modules from
5.22 (or earlier)
In the case of a Kaleido Software multiviewer that contains output cards
equipped with the optional KXO-HDM module, upgrading to version 5.30 or
later, from an earlier version of the Kaleido Software requires precautions.
Before upgrading, you must stop all activity on the monitor wall, through
either of the following methods:
• Remove all input cards.
• Load special layouts that do not contain any video monitor to all heads in
every room associated with the multiviewer, and make sure not to make
any layout change until the upgrade has completed.