GUIDE TO INSTALLATION AND OPERATION
18
| HDA-1911/1931
3.
The Load Factory button is always visible at the bottom of the panel. Click the
Load Factory
button to reset all
parameters on this HDA-19x1 card to factory default values.
The factory default values are shown underlined in the menus found in the Annex to this document, beginning
on page 27.
3.4.2 The
Input
panel
This panel allows the user to
select the input that will be
processed through the
available channels in the
HDA-19x1.
HDA-1911: Only one channel
is available, so
channel B does
not appear in the
panel
HDA-1931: Two channels are
available. The
rear panel may
have one or two
electrical inputs,
and may have
two optical inputs.
Channel B will be
greyed out if no
signal is available
for it.
Input Config
Select the input for Channel A and Channel B, using the radio buttons.
Electrical Input A and Optical Input A can only go to Channel A
Electrical Input B can only go to Channel B
Optical Input B can go to either Channel A or Channel B
Reclocker
Use the radio buttons to independently turn the reclockers for Channels A and B ON or OFF
Figure 3.4
Input panel
– HDA-1911 (left) and HDA-1931 (right)
