Belden Grass Valley GV Korona, Руководство пользователя

Страница: 254 / 433

254
Device Control
Router Control of Aux Buses
Router Control of Aux Buses
The GV Switcher can be configured to allow Encore and Prelude control systems, including
standalone Prelude Control Panels, to control Aux bus source selections.
All switcher Aux buses can be configured to appear on the Router Control System. Aux
buses that are not enabled for router control are seen as being ‘protected’ by the switcher
to the Router Control System. In other words, an Aux bus’ current status (source selection) is
displayed but it cannot be controlled by the Router Control System.
If an Aux bus is enabled for router control, then the source can be changed by a configured
Router Control Panel.
Control Aux Bus Source Selections from a Router
Aux buses are enabled for control in the Eng Setup, Outputs menu.
Enable the Aux Buses for router control:
1 Select the Aux button in the Output Type.
2 Select a Aux 1-46 data pad in the Logical Aux Bus pane to designate it for router control.
3 Select the Router Control selector button (highlights green when selected).
Repeat Steps 1-3 for each Aux Bus you wish to control by router.
Note: Prelude Control Systems are limited to selecting the first 128
switcher sources.