Belden Grass Valley GV Korona, Руководство пользователя

Страница: 228 / 433

228
Device Control
Build an Event List
3 Set up the Control Panel to the desired state, making sure the DDR source is not
selected on the PGM PST A bus. DDRs cannot cue and buffer instantaneously, so should
not be placed on-air immediately when the effect is recalled.
4 Learn this state to an E-MEM register.
5 Select the Clear Events button on the right to deselect the Load command. This helps
prevent accidentally creating unwanted load and cue commands when editing effects
later.
6 Make sure Auto Start is on in the Devices, Control menu. Each device has its own auto
start flag. Note that this is not a keyframeable E-MEM control, and so it must be selected
manually for use.
7 Recall the register. The clip will load.
8 After allowing sufficient time for the clip to load and buffer (which varies with different
DDR models), take the DDR on-air. The clip will play automatically.
Build an Event List
The event list editor is designed for speed and does not follow traditional editing
operations. For example, a normal insert operation would have the operator select the
insert point in the event list, select the clip to be inserted in the browser, and then press
Insert Before or Insert After . Instead, the Event List editor makes insert and replace
operations a mode and modifies what happens when a clip in the browser is selected. This
allows an event list to be built by turning on Insert After, then selecting clips in the order
they should appear in the event list. An insert operation is reduced from two button
selections to only one.
1 Select Devices , Event List in the menu.
2 Select the Insert button so its indicator is illuminated.
3 Scroll the Clip Browser and select the first clip for the list. It will be added to the Event
List in the right pane, and the Insert button legend will change to Insert After .
4 Continue to select clips in the desired order with the Insert After button on to build the
rest of the Event List.
5 If you need to re-arrange the order of the clips in the Event List, use the list editing
buttons ( Move Up , Move Down , etc.). Remember to first select the clip in the Event List
where you wish the re-arrangement to occur before you use these buttons.
6 When the Event List is complete, it can be used for your production without saving it.
The list will only reside in RAM, however, and so will be lost if the GV Switcher system is
reset.
7 To save the Event List for reuse in the future, select Save List , navigate to the
destination folder (creating a new one if desired), enter a name for the list, and then
select Save.
Note: Because a Stop command was not entered, the clip will continue
to play until it reaches its end or it is stopped.
Notes:
• K-Frame Image Store channels do not support the Gang function.