GUIDE TO INSTALLATION AND OPERATION
20
| SME-1901 / 1911
5.9 Factory/Presets panel
Factory
Load Factory
: Clicking this button will restore the card to a
factory default state.
•
Note that User Presets 1-5 and IP settings are not
changed.
•
IP settings can be reset separately using the Reset
IP… button below.
User Presets
The SME-1901 and SME-1911 have five memory registers
which can store user-defined sets of parameter values.
•
The User presets do not include IP parameters.
Select
any one of the five presets using the pull-down list.
The name of the currently-selected User Preset is shown
on the pulldown box.
Click
Load
to load the contents of the selected User Preset
into the SME-1901 or SME-1911. All parameter settings
and values will be replaced by the contents of the selected
User Preset.
Click
Save
to store the current parameter settings and
values from the SME-1901 or SME-1911 into the selected
User Preset. The existing contents of the preset will be
overwritten.
Profiles
This section provides the option to save and recover card configurations (current, or as stored in the User Presets) on
an external disk, or to copy them to another SME-1901 or SME-1911 card.
Note: although the SME-1901 and SME-1911 are very similar in most aspects of their operation, the profiles for
these cards are NOT interchangeable, and you must use the card-specific file in the following procedure.
Click on
Profiles
to open the Profile Copy window.
Figure 5-12 Factory / Presets panel
Figure 5-13 Profile Copy window
