Belden GRASS VALLEY DENSITE 3+ FR4, Руководство пользователя

Страница: 21 / 59

9
Densité 3+ FR4
User Manual
Card Installation and removal
1 Open the front door of the frame
2 To install a card into an empty slot, slide the card into the slot with the swivel handle to the
top, and push gently on the handle to seat the connectors. If the card requires a double-
width rear panel or larger to accommodate a large number of connectors, it should be
inserted into the right-hand slot. Inserting the card into the wrong slot will not damage the
card, and will be flagged by the on-card status LED flashing red to indicate that there is no
connection to the rear panel.
N.B. the rear panel must be installed before the card.
3 To remove a card from a slot, tilt the swivel handle on the front of the card to lever the con-
nectors apart, then use the handle to pull the card straight out of the slot.
4 Close the front door of the frame
Note: Detailed information about the rear panel connections is included in the user manual for the
card.
Using Densité 2 cards in the Densité 3+ FR4 Frame
The Densité 3+ FR4 frame supports Miranda Densité 2 series cards. Should you need to install a
Densité 2 card in your Densité 3+ FR4 frame, you will need two adapters – one for the card, and
one for the rear panel. These adapters extend the height of the Densité 2 devices so that they
will fit into the slots of the Densité 3+ FR4 frame. Note that some Densité 2 cards are available
with a 3 RU rear panel, and sold with the card adapter already attached.