16
Installation WLC
Release 04 07/2019
Power switch
Switch for detaching the device from the power supply.
Note:
For an entire detachment from the power supply please unplug the
power connection.
Power connection
Connector for the IEC cable for power supply unit.
Reset button functions
The reset button offers 2 functions, which are called by pressing the
button for different lengths of time. 'Boot' restarts the device and 'reset'
sets the device to the factory settings.
Pressing the button shortly restarts the device. Pressing the button 5 to
10 seconds sets the configuration to the factory settings. The LEDs on the
device light up continuously. Once you release the switch the device
reboots with the restored factory settings.
Some devices suit only for an installation in free accessible areas. The
configuration is deleted by mistake, if a co-worker presses the reset
button too long. Define the behavior of the reset button with a setting in
WEBconfig (LCOS-Menübaum / Setup / Config):
Ignore: The button shows no response to pressure.
Boot only: Pressing the button restarts the device, no matter how long
you press it.
Reset-or-boot (standard setting): A short pressure on the button
restarts the device. Pressing the button 5 to 10 seconds or longer
reboots the device and resets the configuration to its factory settings.
The LEDs on the device light up continuously.
Once you release the switch the device reboots with the restored factory
settings.
Note:
A reset causes the device to start with the default factory settings,
any previous settings are lost. Any access points managed by this WLAN
Controller lose their configuration, depending on the settings of the
standalone operation. The standalone operation is described in the user
manual.
Note:
With the settings 'Ignore' or 'Boot only', you lock the device for being
reset to the factory settings. If you lose the password for a device with this
setting, there is no way to access the device. In this case use the serial
communications interface to upload a new firmware version to the device.
This action resets the device to its factory settings, which results in the
deletion of the former configuration. Further information and help on the
firmware upload via the serial communications interface is available in the
Reference Manual.
Содержание 942 034-001
Страница 28: ......
