Belden 934 815-001, Техническое руководство

Страница: 37 / 72

The integrated web server
Technical manual LioN-Link BusHead EtherNet/IP™
Release 1.1 04/2016
6.3 The Configuration page (Config)
33
6.3.4 Load Config from File
Pressing this button loads a saved configuration file from an external storage
medium (e.g., PC or network drive) on the BusHead. If you need to replace
the BusHead, this option gives you the ability to restore previously saved
configurations. To finally activate the displayed configuration data, you need
to use "Save Config to Device" to load the data into the BusHead's memory
and then reset to activate.
6.3.5 Save Config to File
Clicking this button saves the current configuration/parameterization of the
BusHead and I/O modules in a file. You can then load the stored data on a
compatible or identical BusHead.
6.3.6 Settings
The "Settings" button is used to call the BusHead or I/O module parameters.

BusHead
The following figure illustrates the configurable BusHead parameters:
The functions "Diagnostic Acknowledge" and "Diagnostic Block Mode"
are described in chapter
“Diagnostics processing” on page 49 . The
"Modules Interchange" function can be used to detect I/O modules on the
two LioN link strands replaced after commissioning.
During commissioning, it is recommended to leave the "Modules
Interchange" parameters at the "Accept" setting (default setting). In this
mode it is possible to find the optimal structure and most favorable wiring
solution for the LioN Link system.