Installation and operating manual
EN
14
DRYPOINT
®
M eco control
2.5. Control and display elements
The
DRYPOINT
®
M eco control
drying system is operated using the user interface on the top of the housing. The current
operating status is represented by LED indicators.
Test
Power
+10
10
+5
20
0
30
Value
35 45 55
°C
°C
-5 -15 -26
P
ressure
D
ew
P
oint
∆
∆
...
...
4
5
1
3
2
1
Power LED (green)
Indicator for operating mode and voltage supply
2
Warning LED (red)
Indicator for alarms, errors and malfunctions in
operation
3
Value LED (green)
Indicator for the set point values
4
>>Test<< button
Setting the operating mode or for testing the
solenoid valve function
5
>>Value<< button
Setting the degree of drying or activating the
service mode
4
+
5
Press and hold the >>Test<< + >>Value<< buttons
Unlock software
→
change settings
The pressure points on the >>Test<< and >>Value<< buttons are designed in such a way that inadvertent touching cannot
trigger operating functions. The software is programmed in such a way that a button must be pressed for a longer time
(approx. 0.2 second) to acquire a desired operating function.
If an operation function is initiated with a continuous pressing of the button(s), then the device will indicate the possible
commencement of the operation: All green value LEDs (3) flash. A time span of 10 seconds is then open for the action after
releasing the button(s). Every actuation of a button during this time span will result in the time span being available again
for the complete duration.
Once the action has been completed and no button has been pressed for 10 seconds, then the confirmation for finalising
the action is executed via the control
. All green value LEDs (3) flash.
The system then transfers into normal mode and is controlled on the basis of the prescribed settings.
NOTE
Additional information
For more information regarding the display and the test function of the solenoid valve, see “Operation” on
