Manufactured by:
Beka, Inc.
• 542
Selby Avenue
•
St. Paul, Minnesota 55102
•
USA
1
-
888
-
999
-
BEKA(2352)
•
www.Bekainc.com
PICTURE FRAME EASEL
Your Picture Frame Easel is ready
for use. Place it on a table, hang it on a
Wall with the cord, or use the 2 wall screws to screw
to a wall. Add paper as desired.
Contents:
-
Framed Art Surface
-
Stand
-
Off Blocks & Paper Holder Rod
-
Paper Roll
-
Hardware & Cord
Mounting a Paper Roll:
•
Remove wing nuts and washers from above the stand
-
off blocks.
•
Remove Paper Holder Rod; slide the rod through the Paper Roll.
•
Re
-
position the Paper Holder Rod over the bolts going through the Stand
-
Off Blocks; secure with
washers & wing nuts.
•
To use paper, slide it under the top paper cutter strip, across the art surface and under the cutter
strip at the bottom of your easel.
•
To tear off used paper: Holding the Picture Frame Easel in place, pull paper down to desired point.
Place your hand on the paper still over the art board to hold it in place and tear paper by lifting it
up against the cutter strip. If you prefer, you can place the entire easel on a table for stability; un-
roll paper and tear it off as usual.
Warning –
Adult Assembly Required!
Enclosed hardware includes small pieces,
so may present a choking hazard to children under 3.
Once assembled, an adult should
check hardware periodically for tightness.
Always dispose of unused hardware & plastic bags
appropriately, as it may pose choking hazards .