ART TABLE INSTRUCTIONS
MODEL # 08402
Fig. 1
Fig. 2
Fig. 3
Step 1)
Attach the two legs drilled to hold the paper roll
dowel, to a tray mounting bar using 4 -1 1/4” screws. Be
sure the countersunk holes on the mounting bar are on
top, as shown (figure 1). Do not fully tighten the screws.
Step 2)
Repeat with the second pair of legs (not drilled
for the paper roll dowel) and the other mounting bar.
Step 3)
Place the table top upside down on a cloth (to
protect the top of the art surface and your floor from
scratches).
Step 4)
Position and attach assembled leg sets to the table
top support bars using the 8 remaining screws (figure 2).
Again, do not fully tighten the screws.
Step 5)
Carefully turn the table right side up (figure 3),
place it on a level surface, then tighten all 16 screws. Do
not over-tighten, as this may strip out the threads in the
legs or crack the wood.
Beka Inc., 542 Selby Ave., St. Paul MN 55102 Phone 1-888-999-2352
Your table is shipped with the art surface and paper guides/cutters attached to
the two table top support bars. The remaining assembly steps are described
here. This should take only a few minutes, and requires a phillips screwdriver.
Wood Parts Included:
1– Paper roll dowel
2– Tray mounting bars
1– Paint tray
1– Pre-assembled art surface
4– Table legs
(2 drilled to hold paper roll)
Hardware Included:
2– 2” Carriage bolts
4– Washers
2– Wing nuts
2– Brass screws
2– Retainer buttons
16– # 10 X 1 1/4” wood screws
Tray mounting bars
Table legs
