5.
Operation of the engineered sewing station
5.1
Feeding the workpieces and starting the sewing process
The engineered sewing station 1280/5 works semi-automatically at
high speed.
The operator of the sewing station has to do the following:
®
call up the desired seam program;
®
feed the workpiece precisely;
®
start the sewing process by foot switch;
®
supervise the sewing process of the unit;
®
remove the finished parts from the stacker.
Feeding the trousers part and starting the sewing process
1) Select the seam program at the control panel (see chapter 6.3).
2) Place the trousers parts on the preparation table and align them.
3) Hold the trousers part to be processed with the left hand.
4) Seize the trousers parts to be processed with the right hand in such
a way that the middle finger is under the lower trousers part, the
forefinger between both parts and the thumb on the upper trousers
part.
5) Hold the trousers parts in front of the feeding aid in such a way that
the three guides of the feeding aid can move under (3), between (2)
and above (1) the trousers parts.
6) Actuate the foot switch.
The feeding aid moves forward and closes.
7) Position the trousers parts guided by the feeding aid under the
sewing foot until the feed-dogs seize them safely.
8) Switch the contour guide on again in the hip bow area by stepping
back on the pedal.
9) Release the trousers parts shortly before the end of the sewing
process.
The remaining sewing process is done automatically.
–
The holding stamp is lowered to avoid that the trousers parts slide
away.
–
The finished trousers parts are stacked.
1
11
3 2 1