Beisler 100, Руководство по эксплуатации, Страница: 30 / 78

2-10
7 Distance of seam end revs [5 mm] (0 - 99 mm)
distance with the revs of parameter 5
8 Stitch length seam start [1,5 mm] (0,5 - 3 mm)
stitch length at seam start for tack or stitch condensation
9 Stitch length in the seam [2,4 mm] (0,5 - 3,5 mm)
10 Stitch length seam end [1,5 mm] (0,5 - 3,0 mm)
freely selectable, effects on tack and stitch condensation at seam end
11 Distance stitch length seam start [10 mm] (0,5 - 99 mm)
distance with stitch length of parameter 8
12 Distance stitch length seam end [10 mm] (0,5 - 99 mm)
distance with stitch length of parameter 10
13 Tack length seam start [10 mm] (0 - 20 mm)
if this value is set to 0, stitch condensation will be sewed automatically
14 Tack length seam end [10 mm] (0 - 20 mm)
if this value is set to 0, stitch condensation will be sewed automatically
15 Slope at seam start [3 mm] ( 0 - 10 mm)
seam offset (difference left/right needle) at seam start
16 Slope at seam end [3 mm] (0 - 10 mm)
seam offset at seam end
17 Enable center knife [17 mm] (0 - 30 mm)
depending on seam and knife width, the center knife should cut est. 1
mm further than the mitre knife
18 Disable center knife [0 mm] (0 - 30 mm)
depending on seam and knife width, the center knife should cut est. 1
mm further than the mitre knife
19 Thread monitor on after [30 mm] (0 - 99 mm)
distance after which the thread monitor will be enabled; change this
parameter if seam length < 30 mm
20 Thread monitor filter [07] (00 - 99)
the smaller the digit, the more sensitive the upper thread monitor
reacts; 99: thread monitor disabled
21 Length vylene seam start [60 mm] (0 - 99 mm)
vylene overlay at seam start
22 Length vylene seam end [80 mm] (0 - 99 mm)
vylene overlay at seam end
23 Duration final roller [0,5 Sek.] (0 - 99 Sek.)
exact positioning of the work piece to be stacked
24 Intermediate stop sel pos. [0 cm] (0 - 48 cm]
enter a position, where the main clamp shall be driven to after
stacking; 01 cm = main clamp is driven to the insertion station
25 Pick up part sel pos. [0 cm] (0 - 48 mm)
if a value is defined, the main clamp pressure is released after mitre
cutting automatically and the work piece will be driven to the set
position; 01 cm = work piece is driven to the insertion station
26 Revs center knife [40%] (10 - 99%)
definition of the cutting speed
27 Revs final roller [99%] (10 - 99%)
a reduction achieves an optimized positioning for the stacking
30 Flap clamp mode >> see further below
31 Folding slide mode
00: left + right fold slider enabled
01: left fold slider enabled
02: right fold slider enabled