WARP DISTORTION WD300
Ultimate Warp Distortion Effects Pedal
Thank you for showing your confidence in us by purchasing the BEHRINGER WARP DISTORTION WD300.
This high-quality effects pedal enables you to produce super thick, tube-like distortion plus
endless sustain. Thanks to its high-performance features you can achieve the typical hard rock
or heavy metal distortion sounds.
1. Controls
(1)
The
SUB
switch activates a low-frequency boost at around 90 Hz to simulate the resonance
frequency of a 4 x 12" cabinet.
◊
CAUTION: The SUB filter is not suitable for all speakers and combos!
(2)
The
LEVEL
control adjusts the output level.
(3)
The
WARP
control adjusts the mid-frequency range. It boosts the mids from 250 Hz to 1 kHz at
minimum position. In maximum position it cuts mids at 500 Hz with a presence boost at 3 kHz.
(4)
The
GAIN
control adjusts the input sensitivity and the amount of resulting distortion.
(5)
The
ON/BATT
LED illuminates when the effect is activated. It also serves as a battery
level indicator.
(6)
Use the footswitch to activate/deactivate the effect.
(7)
Use this 1/4" TS
IN
connector to plug in the instrument cable.
(8)
The 1/4" TS
OUT
connector sends the signal to your amp.
Use the
DC IN
connection to plug in a 9 V power supply (not included).
The
BATTERY COMPARTMENT
is located underneath the pedal cover. To install or replace the 9 V battery
(not included), press the hinges with a ballpoint pen and remove the pedal cover. Be careful not to
scratch the unit.
(5)
(1)
(7)
(4)
(6)
(3)
(2)
(8)
