BEHRINGER V-TONE ACOUSTIC ADI21
WELCOME TO BEHRINGER
Thank you for showing your confidence in us by purchasing
the V-TONE ACOUSTIC ADI21. This high-quality acoustic guitar
driver is designed for all acoustic guitar players who are looking
for more sounds to reach maximum flexibility and creativity.
Thanks to its high-performance EQ section (including parametric
mids) and the integrated Tube/Microphone Emulation, the ADI21
gives your guitar natural sound with smooth saturation, just as if
it were being miked. In addition, the ADI21 functions as a standard
ultra-transparent direct injection box when used in bypass mode.
A DI (Direct Injection) box allows you to send a signal directly
from an unbalanced, high-impedance output (like an electric guitar)
and connect it directly to the balanced mic input of a mixing
console.
Whether for stage, recording, rehearsal or warm-up,
BEHRINGERs V-TONE ACOUSTIC ADI21 is a natural choice for
those who are seeking great tone with a simple set-up.
CONTROL ELEMENTS
Control elements
The
TREBLE
control governs the high-frequency range of
the signal (+/-12 dB).
The
BASS
control allows you to boost/cut the low-
frequency range (+/-12 dB).
Use the
MID
control to boost or cut the mid-range
frequencies (+/-12 dB). The
MID FREQ
control lets you
select the middle frequency (170 Hz to 3.5 kHz) that will be
boost/cut.
The
LEVEL
control adjusts the output level of the ADI21.
The
BLEND
control activates the integrated tube/
microphone emulation circuitry. In most cases, you will
probably set it to maximum (100%). If you want to hear
some of the distinct timbre of a piezo pickup or reduce the
amount of compression, simply turn the control
counterclockwise.
When activated, the
GND LIFT
disconnects the ground
connection between input and output. Depending on the
grounding of the connected equipment, this can eliminate
hum or ground loops.
The
-20 dB PAD
switch attenuates the output level of the
BAL OUT (see
) by -20 dB. It should be activated
when the output level is too high for the microphone input
of the mixer channel.
+
Before using the PAD switch, be sure that it is the
mic preamp on the mixing console that is clipping
and not the ADI21. You should only attenuate the
output signal via the PAD switch if the CLIP LED of
the mic channel lights up frequently or remains
lit.
Use the footswitch to activate/deactivate all the tone
functions (EQ, microphone/tube emulation). When
deactivated, the ADI21 functions solely as a standard
transparent DI box.
This LED illuminates when the effect is activated (see
).
Connectors
Use this 1/4" TS
INPUT
connector to plug in the instrument
cable of your acoustic guitar or other instruments.
BAL OUT
is the ADI21s balanced mic level output. Use a
high-quality, balanced XLR (microphone) cable to connect
the driver to a mixing console.
The unbalanced 1/4" TS
OUT
connector sends the signal
to your guitar amp.
Bottom of the ADI21
SERIAL NUMBER
. The serial number of the ADI21 is
located on the bottom.
BATTERY COMPARTMENT
. Open the lid to install or
replace the 9 V battery (see also chapter POWER
REQUIREMENTS).
+
The ADI21 is powered as soon you insert a plug
into the INPUT. The battery is disconnected when
the plug is removed. For this reason, the ADI21 has
no on/off switch. To prolong battery life, always
disconnect the input when the driver is not in use.
Power supply connector
All manuals and user guides at all-guides.com
all-guides.com
