INSTRUCTIONS
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be followed including the following:
1.
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
2. Turn off power supply before attempting to install the unit
3. Do not let power cords touch hot surfaces
4. Do not mount near gas or electric heaters.
5. Equipment should be mounted in locations and at heights where unauthorized personnel will not readily subject it to
tampering.
6. The use of accessory equipment not recommended by Beluce Canada Inc., may cause an unsafe condition, and will
void the unit’s warranty.
7. Do not use this equipment for other than its intended purpose.
8. Qualified service personnel should perform servicing of this equipment.
9. Consult building code for approved wiring and installation
10. The fixture must be grounded to avoid potential electric shock
11. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
12.
SAVE THESE INSTRUCTIONS!
INSTALLATION
NOTE: DC Polarity is critical yellow lead is positive and purple lead is negative. Reverse polarity connection will
damage LED boards and void warranty.
1. Remove the lens by placing an appropriate sized flat head screw driver into the snap lock clips and pushing the clips
slightly in and down until they release the lens. This must be completed to each of the four clips (Figure 1).
2. Pull the lens away from the unit. The internal reflector and chassis can now be removed by placing the screw driver
into the reflector locking channels and twisting slightly until the clip releases. This must be completed to each of the
four mounting channels (Figure 2). For recessed installation see (Figure 3)
3. Pull the reflector and chassis away from the back plate.
4. Bring the DC wires into the housing through the top or back knockout hole using a matched conduit fitting (supplied by
others).
5. Surface, wall or ceiling installation can be completed by installing screws and washers (supplied by others) with a
waterproof cap through the back of the fixture housing (Figure 4).
6. Connect 12V or 24 VDC to yellow (po) and to purple (negative - ).
7. Re-align the reflector with the back plate and push together until each locking clip engages (Figure 5).
8. Align the lens with the unit and push in back into place until each lens snap lock clip engages.
WALL MOUNTING
Fixture is shipped with LED strips positioned for ceiling mounting. To improve light distribution for wall mounting
(Figure 10) configure unit as follows:
1. Test switch holes indicates bottom of fixture (Figure 6)
2. Ensure locating pin goes through slot in LED strip (Figure 7)
3. Un-snap bottom LED strip and gently snap into middle notch and lower notch (Figure 8)
4. Un-snap top LED strip and gently snap into lower notch and upper notch (Figure 10)
Tempesta™ LED Remote (TA-RMT-LED)
926000332
MAINTENANCE
1. The equipment is to be repaired whenever the equipment fails to operate as intended during the duration test.
Written records of test results and any repairs made must be maintained. Beluce Canada Inc. strongly recommends
compliance with all Code requirements.
2. Clean lens on a regular basis.
NOTE: The servicing of any parts should be performed by qualified service personnel only. The use of replacement parts
not furnished by Beluce Canada Inc., may cause equipment failure and will void the warranty.
The LEDs listed herein when used according to the instructions with this unit are in accordance with the requirements of
CSA Standard C22.2, No. 141 – Unit Equipment for Emergency Lighting.
Beluce Canada Inc., 3900 14th Avenue, Markham, ON L3R 4R3 Tel: (905) 948-9500 Fax: (905) 948-8673
06/09/2019
