BEGHELLI USA 3250 CORPORATE WAY • MIRAMAR, FL 33025 P: 800.726.4316 • P: 954.442.6600 • F: 954.442.6677 • WWW.BEGHELLIUSA.COM
HDZ Combo (HDZ)
INSTRUCTIONS
IMPOR
T
ANT SAFEG
UARDS
When using electrical equipment, basic safety precautions should always be followed including the following:
1.
READ AND FOL
L
OW ALL SAFETY INSTRUCTIONS
2. Disconnect power before performing work on electrical equipment.
3. Do not use outdoors.
4. Do not let power cords touch hot surfaces and do not mount near gas or electric heaters.
5. Use caution when servicing batteries. Battery acid can cause burns to skin and eyes. If acid is spilled on skin or
eyes,
fl
ush with fresh water and contact a physician immediately.
6. Equipment should be mounted in locations and at heights where unauthorized personnel will not readily
subject it to tampering.
7. The use of accessory equipment not recommended by Beghelli USA may cause an unsafe condition,
and will void the unit’s warrant
y.
8. Do not use this equipment for other than its intended purpose.
9. Servicing of this equipment should be performed by quali
fi
ed service personnel.
10.
SAVE THESE INSTRUCTIONS!
INSTALLATION
1. Extend leads supply of rated voltage to junction box (supplied by others). Leave at least twelve (12) inches of slack wire. The
circuit should not be energized at this time.
2. All HDZ units are made of cast aluminum to meet the requirements of the classi
fi
cation and division rating. As such, the product
is heavy. Securely mount the HDZ unit via secure pendant, ceiling or wall mount surface ensuring the appropriate supports are in
place to maintain the weight load rating. Mounting hardware is to be supplied (by others).
3. The cast aluminum base should meet with the appropriately rated conduit for wire feed.
4. Connect the conduit to the cast aluminum base by removing one of the wire access plugs. Ensure all other plugs are securely
fastened to the maximum torque in ft/lbs. A self sealing connect
or must be used. All wire access plugs are ¾” npt and can be
r.
5. Route wires through the product to the neck of the product and m
ake wire connections inside the housing by unscrewing the 3”
diameter wire junction nut.
6. Once electrical connections are made be sure to insulate unused wire!. Failure to insulate unused wire may result in a shock
hazard or unsafe condition as well as equipment failure.
7.
Re-thread the 3” diameter wire junction nut to ensure closure of
the opening.
8. Ensure power is supplied.
Please note – Class 1 division 1 remotes or battery units to not have
a removable glass lens. An attempt to remove the lens will cause
damage and break the seal voiding the classi
fi
cation and division of the
fi
xture. Class 2 division 2 remotes or battery units do have
a removable glass and self sealing gasket design for maintenance purposes
926000126
05/22/2013
