BEER Uno Top Hot, Инструкции по установке и запуску

Страница: 5 / 25

Beer Grill AG Beer Grill GmbH
Allmendstrasse 7 Tel. +41 (0)56 618 7800 Körnerstrasse 14 a Tel. +49 (0)71 61 659 876 info@beergrill.com
CH
– 5612 Villmergen
Fax +41 (0)56 618 7849 D
– 79539 Lörrach
Fax +49 (0)71 61 659 879 www.beergrill.com
Seite 5
2.3 Attention! Danger of burning!
The following parts will become very hot, when Uno Top is activated and, if touched, it exists
danger of burning:
-
Ceran plate, if heating elements switched on and until they are completely cooled
down.
- Water bins and parts which are in touch with it.
- Infrared heater and lamp housing
- Cover of illumination bridge
Before water bins are drained (tap) and/or taken out, the Uno Top has to be cooled
down completely. This should also happen, before Uno Top is displaced.
2.4 Procedure by lamp bursting and breakage of glass
The infrared lamps are equipped with a shatter protection. This protection prevents touching
of lamps. In case of lamp bursting (infrared and compact fluorescent lamps) glass shelves,
sneeze screen, front and lateral glasses, proceed immediately as follows:
- Switch off and close counter.
- Self-service counter: Avoid guests taking food contaminated with glass splinter.
- Collect and replace all plates filled with food of guests, who have been nearby when
the incident happened.
- Take out all food containers of the counter. Dispose food in rubbish bin (not in bin for
leftovers).
- Take off shatter protection glass of defective lamp and clean it.
- Clean the Uno Top and floor.
- Replace broken items.
- Refit shatter protection glass with bracket.
- Refill counter.
- Counter is ready for reopening.
2.5 Glazing / Danger of accident
Incorrect, badly mounted or damaged glass may fall out and cause serious injuries. Be sure
to check before opening the self-service counter, but also after cleaning the glass (especially
the front- glass) if:
- The glass is placed properly e.g.: In the lower glass holders in the intended slots (not in
the rack separations, nor the discontinued racks). Both sides in the above designed
mounted holders.
- The glasses have no damage (damaged edges and corners = cut risk and insufficient
support). The safety glass may crack or burst due to internal tension, even without contact
with the damaged edge.
- The glass holder for damage and upper front holder (customer side) is well fitted. (Upper
part must rest on the upper glass edge). These holders are glued. Loosen holders must
be re-glued by qualified personnel. If the glass holder moves upwards, the upper stop ridge
(arrest) of the front glass may be affected and the glass can fall out by strong contrast
shock.
Damaged glass panels must be replaced immediately, glass holders refitted by
qualified personnel. In a pinch, continue working without the glass panels until the
required spare parts arrive.