BEER Uno Top Cold, Руководство по эксплуатации, Страница: 8 / 28

Beer Grill AG Beer Grill GmbH
Allmendstrasse 7 Tel. +41 (0)56 618 7800 Körnerstrasse 14 a Tel. +49 (0)71 61 659 876 info@beergrill.com
CH
– 5612 Villmergen
Fax +41 (0)56 618 7849 D
– 79539 Lörrach
Fax +49 (0)71 61 659 879 www.beergrill.com
Seite 8
Caution
Access to the control box and to all other electrical parts during installation and/or
maintenance work is only permitted for qualified specialists
4.3 Procedure by lamp bursting and breakage of glass
In case of lamp bursting glass shelves, sneeze screen, front and lateral glasses, proceed
immediately as follows:
•
Switch off the appliance and close the counter.
•
Self-service counter: Avoid guests taking food contaminated with glass splinters.
•
Collect and replace all plates filled with food of guests, who have been nearby when the
incident happened.
•
Take out all food containers of the counter. Dispose food in rubbish bin (not in bin for
leftovers).
•
Take off shatter protection glass of defective lamp and clean it.
•
Clean the appliance and its environment (counter and floor).
•
Replace broken items.
•
Refit shatter protection glass with bracket.
•
Refill counter.
•
Counter is ready for reopening.
4.4 Glazing/Danger of accident
Beer counters are equipped with one sheet safety glass (ESG).
Incorrectly, badly mounted or damaged panels may fall out and cause serious injuries. Be
sure to check all glazing before opening the self-service counter, but also after cleaning the
glass (especially the front- glass) that:
•
The panel or shield is placed properly e.g.: In the lower glass holders in the intended
slots (not in the rack separations, nor the discontinued racks). Both sides in the above
designed mounted holders.
•
The panels have no damage (damaged edges and corners = cut risk and insufficient
support) . The safety glass may crack or burst due to internal tension, even without
contact with the damaged edge.
•
The glass holder is not damaged and the upper front holder (customer side) is well fitted.
(Upper part must rest on the upper glass edge). These holders are glued. Loose holders
must be reglued by qualified personnel. If the glass holder moves upwards, the upper
stop ridge (arrest) of the front panel may be affected and the panel may fall out if struck.
!