BEER GN-2/1, Руководство по эксплуатации, Страница: 9 / 27

Beer Grill AG Beer Grill GmbH
Allmendstrasse 7 Tel. +41 (0)56 618 7800 Körnerstrasse 14 a Tel. +49 (0)71 61 659 876 info@beergrill.com
CH
– 5612 Villmergen
Fax +41 (0)56 618 7849 D
– 79539 Lörrach
Fax +49 (0)71 61 659 879 www.beergrill.com
Page 9
i
6 Transport of Hot Cube
Use special caution when transporting or moving the appliance in order to avoid damage
from impact, carless loading and unloading or shock. The appliances are self-supporting. It
still has to be used a solid base for transport with the dimensions corresponding to those of
the appliances.
Immediately check the delivery after receipt for completeness and transport damage. In case
of externally recognisable transport damage, do not accept the delivery or accept only with
reservation. The extent of the damage must be noted on the transport documents/delivery
note and a complaint started.
File a complaint immediately for hidden damage, since compensation claims can
only be asserted within the existing complaint period.
7 Installation of the Hot Cube appliances
The following points must be observed when setting up the appliances:

Solid substructure
The appliances are self-supporting. The substructure should have the same basic
dimensions as the appliance.

Ambient temperature
The appliances are equipped with electronic components that are ventilated Therefore
do not place any heat producing apparatus nearby (Griddle, Bainmarie, etc.).

Built-in units
The appliances may only be installed by qualified and authorized experts. The exact
installation instructions can be found in the appendix.
When installing units in a niche or cut out of a table top you have to assure the airflow
of the forced air-circulation. For handling and thermal reasons we recommend the first
version.

Installation site and storage
The appliances contain electronic components that may not be stored in cold and humid
areas. Make sure that no condensate water can form during storage.
If an appliance has been out of service for a prolonged time and has been stored in a
cool or humid area, it must be thoroughly checked before restarting.
Contact with salt water is strictly forbidden. If an appliance is installed at a swimming
pool, it is essential to assure that the equipment does not get in contact with substances
containing chlorine or acids that may affect the anti-corrosive protection of the metal
construction.