6
7
CARE AND MAINTENANCE
OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS
Operation of the optional side burner
Lighting
1. Check the control knob is in the Off position and ensure
the gas line is properly connected.
2. Raise the lid and check that the burner and burner cap
are in the correct position.
3. Press and turn the control knob slowly (3-4 seconds) in
a counter - clockwise direction to the High position until
a click is heard. When the burner is alight, select your
desired heat setting. A low flame or simmer condition
is obtained by turning the control knob anti-clockwise
to Low.
4. If the burner fails to ignite, turn the control knob to Off,
wait 5 minutes and repeat the lighting procedure.
After Use
1. Turn the control knob to the Off position and turn the
gas cylinder valve off when the barbecue is not in use.
2. Clean off any food spills and then close the lid.
WARNING
WARNING
When using the side burner ensure that any handle fitted to
a wok, pot or pan is positioned so that it is out of reach
of children.
WARNING
WARNING
Safety with woks and pots and pans
When using a wok, pot or pan on the side burner ensure
that any handle is positioned so that it is out of reach of
children. Long handles protruding out beyond the side
burner can be dangerous. Keep children away from the
appliance when it is operating. Never leave an operating
barbecue unattended.
Low
High
Off
Always open
lid before
lighting.
Do no close
lid while
burner is
alight.
Long handles
protruding
out beyond
the side
burner can be
dangerous.
CARE AND MAINTENANCE
Stainless steel cleaning and maintenance
Clean the appliance as required or at least twice annually
with hot soapy water. Avoid abrasive cleaners or brushes
as these will mark the porcelain enamel or stainless steel
surfaces of the appliance. If you cook food directly over the
burner flame, causing more vapour or smoke, the viewing
glass (where fitted) will need more frequent cleaning.
Stainless steel care and cleaning
After the appliance has been used, wash down the surfaces
with hot soapy water. The surface of the stainless steel
has a grain. Always clean along the grain of the steel. This
will avoid unwanted marks. Near the ocean or salt-water
environment, wash regularly, rinse and then dry before
covering. Covering a salt sprayed stainless steel product
while still wet will allow salt deposits to form, causing rust to
form even on very high grade stainless.
Discoloration of stainless steel
The discoloration of stainless steel, caused by high heat is
caused by Chromium Oxide and sometimes appears as a
light brown colouring over the surface of the steel. In most
cases, this discoloration can be removed with a suitable
stainless steel polish.
NOTE: Discoloration of the stainless steel is not covered
under warranty.
Porcelain enamel cleaning and maintenance
After the appliance has been used, wash down the surfaces
with hot soapy water. Near the ocean or salt-water
environment, wash regularly, rinse and then dry before
covering. Highly caustic cleaners should be avoided.
IMPORTANT
Care should be taken with all cleaning agents to avoid
damage to any associated non-stainless steel components.
Fire, safety and protective clothing regulations should be
closely adhered to.
Rust
Cast iron and steel are metals and will rust if you do not
provide sufficient maintenance and care. Rust occurs when
the surface of the metal starts to oxidise. Generally, rust will
occur on any exposed metal surface if it is not protected from
the elements. Even stainless steel can be affected by long
term exposure to the elements. To prevent exposure to the
elements, store your barbecue, hood and trolley under the
protection of a purpose made cover.
Do
• Wash regularly with warm soapy water or detergent
using a clean cloth and, if necessary, a soft bristle
brush.
• Remove non-washable deposits using an approved
cleaner.
• In the case of stainless steel, clean in one direction only,
along the original polish lines.
• Rinse well with clean water and wipe dry.
• Keep barbecue covered when not in use. eg polyester
barbecue cover.
Don’t
• Use steel wool or metallic scrapers to remove non-
washable deposits.
• Allow grease or dirt to accumulate or to dry out
and harden.
• Use cleaners containing harsh abrasives or high
bleach content.
CONDITION
CLEANING PRODUCT
METHOD
Readily removed
stains
Light grease
Routine cleaning
Salt spray
Soap, liquid detergents, or powder detergents
with warm water. Methylated spirits may be
used before final wash with detergent.
Avoid scratching. Do not use cleaners containing
bleaching agents. Rinse with clean water to
remove residual cleaning compounds and dry
before covering. Only use mild detergents on
barbecue fascia.
Non washable
deposits
Heavy grease
Concentrated detergent. Domestic cleaning
powders. Recommended stainless steel
cleaners.
Do not use steel wool. Rub in straight lines
along the polish pattern. Avoid scratching.
scratching. Rinse with clean water and dry.
