Becom Argos3D-P23X, Быстрый старт

Страница: 6 / 15

© BECOM Systems 2019
6
|
15
Quick Start Guide - Argos3D-P23X
Last change: 30 January 2019/Version 2
Note
Please follow the next steps in the right order to get your ‘Argos3D - P23x’ up and running
correctly.
1.3.1 Connecting the break-out board
Please connect the break-out board to the Argos3D-P23x common connector first.
Figure 1-2: Argos3D – P23x common connector
1.3.2 Connecting the power supply
To ensure, that your Argos3D – P23x works correctly, connect the ‘Argos3D’ to a 12-30V DC power supply using
connector (a) and wait for approximately 20 seconds until the camera boots up.
Pin assignment on the power connector (a): Pin #1: +12V to +30V, Pin#2: GND
Note
The power supply connector is protected against wrong polarity but the ‘Argos3D’ will not
work in case you don’t use the correct polarity! If the
Argos3D – P23x doesn’t work please
check the power supply polarity first!