Beckoff PS2001-2410-0000, Документация

Страница: 14 / 40

Technical data, mounting, wiring
PS2001-2410-0000 14 Version: 1.0
3.4 Output
Output voltage Nom. 24V
Adjustment range Min. 24-28V Guaranteed value
Max. 30.0V This is the maximum output voltage that can occur in the end position of the po-
tentiometer in clockwise direction due to tolerances. It is not a guaranteed
value that can be achieved.
Factory settings Typ. 24.1V ±0.2% at full load (cold device)
Line regulation Max. 10 mV Between 85 and 300Vac
Load regulation Max. 50 mV Between 0 and 12A, static value, see Fig. Output voltage over output current,
typ.
Residual ripple and ripple
voltage Max. 50mV
ss
Bandwidth 20 Hz to 20 MHz, 50 Ohm
Output current Nom. 12A
1)
At 24V and an ambient temperature below 45°C, see Fig. Output current over
ambient temperature
Nom. 10A At 24V and 60°C ambient temperature, see Fig. Output voltage over output cur-
rent, typ.
Nom. 7.5A At 24V and 70°C ambient temperature, see Fig. Output current over ambient
temperature
Nom. 10.3A
1)
At 28V and an ambient temperature below 45°C, see Fig. Output current over
ambient temperature
Nom. 8.6A At 28V and 60°C ambient temperature, see Fig. Output voltage over output cur-
rent, typ.
Nom. 6.45A At 28V and 70°C ambient temperature, see Fig. Output current over ambient
temperature
Typ. 30A For at least 12ms once every five seconds, see Fig. Dynamic output current ca-
pacity, typ . The output voltage remains above 20V.
See chapter on Peak current capability [ } 28] for further peak current mea-
surements. For AC 100V networks the pulse length is shorter than 12ms.
Overload behavior Continuous cur-
rent Output voltage > 13Vdc, see Fig. Output voltage over output current, typ.
Hiccup mode
2)
Output voltage < 13Vdc, see Fig. Output voltage over output current, typ.
Short circuit current Min. 12.5A
3)
Load impedance <45mOhm, see Fig. Short circuit at output, hiccup mode, typ.
Max. 15.5A
3)
Load impedance <45mOhm, see Fig. Short circuit at output, hiccup mode, typ.
Max. 5A RMS value of current, load impedance 50mOhm, see Fig. Short circuit at out-
put, Hiccup mode, typ.
Min. 28A Up to 12ms, load impedance <45mOhm, see Fig. Dynamic output current ca-
pacity, typ .
Typ. 30.5A Up to 12ms, load impedance <45mOhm, see Fig. Dynamic output current ca-
pacity, typ.
Output capacity Typ. 4 400μF Included in the power supply
1)
Extra Power
This continuous power / current is permissible up to an ambient temperature of +45°C. Above +45°C, use
this power / current for a maximum duty cycle of 10%, i.e. no more than 1 minute every 10 minutes.
2)
Hiccup mode
In the event of heavy overload (when the output voltage drops below 13V), the power supply provides
continuous output current for 2s. The output is then switched off for about 18 seconds before a new switch-
on attempt is automatically made. This cycle is repeated as long as the overload persists. After the overload
has been rectified, the device will operate normally. See Fig. Short circuit at output, hiccup mode, typ.
3)
The discharge current of the output capacitors is not included.