Beckman Coulter CEQ 8000, Руководство пользователя

Страница: 342 / 382

Direct Control and Replenishment
328 CEQ™ 8000 Genetic Analysis System
Accessing the Direct Control Window
From the CEQ Toolbar, click on the
RUN
icon. Verify that the Run window is
displayed and then click on the
Direct Control
tab.
Direct Control Procedures
Replacing the Wetting Tray
Removing the Wetting Tray
1. Select
Replenish | Replace Wetting Tray
from the Run Module main menu.
2. Press
OK
when prompted to verify this action.
3. Open the Sample Access Cover (Figure 190) and lift to the vertical locking
position.
4. Remove the sample plate and set aside.
5. Rotate the Wetting Tray Retainers outwards to release the Wetting Tray.
6. Lift the Wetting Tray vertically.
Installing the Wetting Tray
1. Select
Replenish | Replace Wetting Tray
from the Run Module main menu.
2. Press
OK
when prompted to verify this action.
3. Open the Sample Access Cover (Figure 190) and lift to the vertical locking
position.
4. Rotate the Wetting Tray Retainers outward. Insert the Wetting Tray into the
receptacle between the Sample and Buffer plates (Figure 191) and then gently
press it down into the well.
5. Rotate the Wetting Tray Retainers inwards to lock the Wetting Tray in place.
If a sample plate is installed in the system, it must be removed before
installing the wetting tray to allow movement of the wetting tray
retainers.