Beckhoff PS9031-4820-0001, Документация

Страница: 22 / 30

Technical data, application notes, wiring
PS9031-4820-0001 22 1.0
4.16 EMC
The EMC behavior of the device is designed for applications in industrial environments as well as residential,
commercial or small business environments.
The device was tested according to EN 61000-6-1, EN 61000-6-2, EN 61000-6-3 and EN 61000-6-4.
This device complies with FCC Part 15.
Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and
(2) this device must be able to deal with any interference received, including interference that may cause
undesired operation.
The signal cables ("Active", "Ready" and "Inhibit") must be shorter than 30 m.
EMC interference immunity
Fast transients (burst) EN 61000-4-4 • Input cables
• Output cables
• Signal cables
Pin 6, 7, 8, 9
**)
Criterion A
*)
2 kV
**)
Tested with connecting terminal.
*)
A: Buffer module exhibits normal operating behavior within the defined limits.
EMC interference emission For standby and charging mode
Conducted interference emission, input lines IEC/CISPR 16-1-2,
IEC/CISPR 16-2-1 Limit values for DC power supply connections accord-
ing to EN 61000-6-3 fulfilled
Interference emission EN 55011,
EN 55022 Class B
Switching frequencies
Charge converter on 48 V input (is only ac-
tive during charging) 6 to 740 kHz The frequency depends on the charge state of the ca-
pacitors
Buffer converter when buffering at 45 V 10 to 85 kHz The frequency depends on the output current. The val-
ues are valid between 10% and 100% of the nominal
buffer current
4.17 Environment
Environment
Operating temperature -25 °C to + 70 °C The operating temperature corresponds to the ambient or environ-
mental temperature and is defined as the air temperature 2 cm be-
low the device.
Storage temperature -40 °C to + 70 °C For storage and transport
Moisture 5 to 95% r.h. According to IEC 60068-2-30
Atmospheric pressure 110-54kPa
Installation altitude up to 5000m
Degree of pollution 2 According to IEC 60664-1, non-conductive
Overvoltage category N/A
Pulse dielectric strength 1.5 kV Between input and chassis (according to IEC 60664-1 overvoltage
category II)
Oscillation,
sinusoidal 2–17.8 Hz: ±1.6 mm;
17.8–500Hz: 2g
2 hours/axis According to IEC 60068-2-6
Impact 30g 6ms, 20g 11ms
3 impacts/direction,
18 impacts in total According to IEC 60068-2-27
The shock and vibration test takes place in combination with DIN rails according to EN 60715 with
a height of 15 mm and a thickness of 1.3 mm and standard orientation.