Beckhoff PS1061-2405-0000, Документация

Страница: 22 / 36

Technical data, mounting, wiring
PS1061-2405-0000 22 Version: 1.0
3.12 EMC
The device allows use in industrial, residential, business and commercial areas as well as in small
businesses.
The device was developed in accordance with EN 61000-6-1, EN 61000-6-2, EN 61000-6-3, EN 61000-6-4,
EN 61000-3-2 and EN 61000-3-3.
This device complies with the provisions of FCC Part 15. Operation is subject to the following two conditions:
1. This device must not cause harmful interference and
2. this device must accept all interference received, including interference that may cause unwanted op-
eration.
Without additional measures to reduce the cable-bound emission at the output (e.g. using filters), the device
is not suitable for supplying a local DC supply network for residential, business and commercial areas or for
small businesses.
In industrial areas the device can be used without additional measures to construct a local DC supply
network.
The device is unsuitable for AC 200 V mains supplies and more than 4.5 A load current, if a short drop in the
output voltage in case of mains interruptions (even with interruptions shorter than 20 ms) is incompatible with
the application.
EMC interference immu-
nity
Strong transients VDE 0160 Over the entire load range 750 V, 1.3 ms
EMC interference emis-
sion According to the generic standards: EN 6100-6-3 and EN6100-6-4
Conducted interference
emission, input lines EN 55011, EN 55022, FCC Part 15,
CISPR 11, CISPR 22 Class B
Conducted interference
emission, output lines
2)
IEC/CISPR 16-1-2, IEC/CISPR 16-2-1 Limit values for local DC networks not
fulfilled
Interfering radiation EN 55011, EN 55022 Class B
Harmonic input current EN 61000-3-2 Requirements for Class A devices met
Voltage fluctuations, flicker EN 61000-3-3 Fulfilled, tested with constant current
loads, non-pulsing
Switching frequencies
Main converter 40 kHz to 120 kHz Output voltage and load-dependent,
min. load 1 A