Beckhoff KL3361, Документация

Страница: 41 / 70

Configuration software KS2000
KL3361 and KL3362 41 Version: 2.2.0
Enable
Connect the lower input of the And gate with the desired function in order to specify when the And gate
should switch through a trigger pulse (
R40 [ } 62] ).
Always enabled The trigger pulse is always switched through.
Digital input High The trigger pulse is switched through, if the trigger input (24 V
trigger) of the oscilloscope terminal is on High potential.
Analog input 1 above
switching threshold The trigger pulse is switched through, if the signal at analog input 1
of the oscilloscope terminal increases above the switching
threshold 2. The threshold level can be specified via the
Trigger
values [ } 43] tab.
(KL3362 only)
Analog input 2 above
switching threshold The trigger pulse is switched through, if the signal at analog input 2
of the oscilloscope terminal increases above the switching
threshold 2. The threshold level can be specified via the
Trigger
values [
}
43] tab.
Digital input Low The trigger pulse is switched through, if the trigger input (24 V
trigger) of the oscilloscope terminal is on Low potential.
Analog input 1 below
switching threshold The trigger pulse is switched through, if the signal at analog input 1
of the oscilloscope terminal decreases below the specified
switching threshold 2. The threshold level can be specified via the
Trigger values [
}
43] tab.
(KL3362 only)
Analog input 2 below
switching threshold The trigger pulse is switched through, if the signal at analog input 2
of the oscilloscope terminal decreases below the specified
switching threshold 2. The threshold level can be specified via the
Trigger values [
}
43] tab.
Action
Connect the output of the And gate with the desired function in order to specify which task should be
triggered.
Reset the timer
(chronometer) to zero
(
R40.2 [ } 62] )
Resets the timer back to zero. The timer will start running again
automatically immediately.
Save timer
(chronometer) (
R40.3
[
}
62] )
Saves the current value of the running timer at the trigger instant.
Set digital output ( R40.4
[
}
62] )
Sets the digital output, e.g. to the synchronous triggers of the
second oscilloscope channel of a KL3362. This function must be
released with bit 2 of the control byte 1 (CB1.2)
Start recording ( R40.5
[
}
62] )
Starts the recording
Enable trigger unit 2
(
R40.5 [
}
62] )
If the output of the And gate in trigger unit 1 is connected with the
function
Enable trigger 2 , the trigger signal is transferred to trigger
unit 2, which can be accessed via the Unit 2 button in the Selection
field for parameterization.
(KL3362 only)
Enable trigger unit 3
(
R40.5 [
}
62] )
If the output of the And gate in trigger unit 2 is connected with the
function
Enable trigger 3 , the trigger signal is transferred to trigger
unit 3, which can be accessed via the Unit 3 button in the Selection
field for parameterization.
(KL3362 only)
Enable trigger unit 4
(
R40.5 [
}
62] )
If the output of the And gate in trigger unit 3 is connected with the
function
Enable trigger 4 , the trigger signal is transferred to trigger
unit 4, which can be accessed via the Unit 4 button in the Selection
field for parameterization.