Beckhoff CPX29 0000 Series, Инструкция по установке и эксплуатации

Страница: 18 / 39

Product overview
CPX29xx-0000 18 Version: 0.2
4.3.3 USB In (X104)
X104
USB type B, PCB installation (FCI 61729-0010B USB Receptacle B-Type)
The Control Panel is connected with the Industrial PC via the USB port ( X 104 , connector type B). USB3.0
standard is supported.
Pin Signal Pin Signal
1 5V 3 D+
2 D- 4 GND
4.3.4 USB-E In (X105)
X105
Connection via standard-RJ45-cabel, not crossed
The Control Panel is connected with the CU8801 USB to USB extended converter box via the USB-
Extended input (
X 105 ).
In order to realize a distance of 50 m without hubs, with USB extended the USB signal is converted so that it
can be transferred via 50 m CAT5 cables commonly used for Ethernet wiring. In the Control Panel the signal
is converted back to USB.
4.3.5 DVI-D In (X106)
X106
DVI-D 3 X 8-pole digital PCB installation (MOLEX 74320-9000 / 74320-9004)
The DVI-D connection (X 106) is used for transferring the video signal from the Industrial PC to the Control
Panel.
The graphics signal is transferred directly via a DVI cable over a distance of 50 m max. Such a cable length
leads to strong distortion of the graphics signal on arrival at the Control Panel. The CPX29xx Control Panel
features a signal processor that restores the DVI signal. The PC requires a conventional DVI output.
Pin Signal Pin Signal
1 Rx2- 13 Rx3+
2 Rx2- 14 + 5V DVI
3 GND 15 GND
4 Rx4- 16 HPD
5 Rx4+ 17 Rx0-
6 DDC CLK 18 Rx0+
7 DDC DAT 19 GND
8 AV SYNC 20 Rx5-
9 Rx1- 21 Rx5+
10 Rx1+ 22 GND
11 GND 23 RxC+
12 Rx3- 24 RxC-