Beckhoff CP32 -2 -0020 Series, Руководство пользователя

Страница: 10 / 45

Product overview
CP32xx-2xxx-0020 10 Version: 1.1
3.2 Interface description
The Panel PC has the following interfaces:
• Power supply (XD01)
• Ethernet (XF01, XF02)
• USB (XG01-XG04 or XG02-XG04)
The interfaces are located at the bottom of the back of the housing. The Harting push-pull built-in power
socket for the power supply as well as one of the two Harting push-pull built-in Ethernet sockets are freely
accessible. The second Harting push-pull built-in Ethernet socket is covered by a protective cap. If you also
need the second interface, remove its protective cap. The USB interfaces are located under screw caps. To
gain access to the USB interfaces, remove the screw caps from the housing (see Fig. 2).
A B
C
Fig. 2: CP32xx_access to interfaces
3.2.1 Power supply
The Panel PC is supplied with a rated voltage of 24 V. The connection of the power supply as well as the
external wiring of the Panel PC is carried out via a Harting push-pull built-in power socket (XD01). There is a
connection cable inside the column unit of the mounting arm. If the Panel PC is used alone, this cable is
intended for the power connection of the PC. If the C900-M800 key extension is also used in addition to the
PC, use the cable for the power connection of the key extension. For the wiring of CP32xx and C9900-M800,
a separate cable is supplied with the key extension.
1 2
3 4
Fig. 3: CP32xx_voltage socket pin numbering
Table 2: Voltage socket pin assignment
Pin Signal Description
1 + 24 V Power supply
2 GND 0 V
3 nc not connected
4 nc not connected