Beckhoff CP22 Series, Руководство пользователя

Страница: 41 / 53

Maintenance
CP22xx 41 Version: 2.0
2. Pull the battery out of the Panel PC with needle-nose pliers (section B).
3. Insert the new battery into the PC by hand. Pay attention to the correct polarity. The negative pole of the
battery must face the display.
A B
Fig. 26: CP22xx_battery replacement
To dispose of the battery, remove it, stick insulating tape over the poles and take it to the local battery
recycling.
7.2.2 Replacing the storage media
For new storage media, please contact your Beckhoff Sales only.
Chapter 7.2 Maintenance [
}
38] shows where the storage media are located.
Data transmission before replacement
If you want to exchange a storage medium according to Beckhoff's recommendation, you must copy the data
from the old to the new storage medium. You can use the Beckhoff Service Tool (BST) for this purpose. BST
is a graphical backup and restore program for PCs with a Windows operating system. You can create an
image of your operating system and use it to back up the operating system. You can then restore the images
created in this way. The BST is available on a bootable BST USB flash drive. This includes Windows and a
backup software. Select the size of the BST USB flash drive according to the size of the backup copy of your
operating system. You can then keep the flash drive as a backup copy. For this purpose, the BST USB flash
drives with SLC flash are designed for a particularly long data preservation. For more information on the
function of the BST, please refer to the corresponding
manual .
If your storage medium is defective and there is no backup, Beckhoff Service can provide you with a fresh
Windows image. For this to be possible, the Beckhoff PC must already have been shipped with a valid
operating system license. When installing the fresh image, the applications must be reinstalled.
Exchange hard disk/SSD
To replace the hard disk or SSD, follow the steps below as shown in Figure 27:
1. Loosen and remove the M4 screw (section A).
2. Fold the cover to the left side (section B).
3. Remove the hard disk or SSD from the Panel PC by pulling on the protruding Beckhoff sticker (section
C).