Beckhoff C9900-G070, Инструкция по установке и эксплуатации

Страница: 19 / 27

Operation
C9900-G070 and C9900-G071 19 Version: 1.0
5 Operation
5.1 Switching the Control Panel on and off
5.1.1 Switching on
The Control Panel does not have its own mains switch. On switching on the power supply the Control Panel
will also be switched on.
5.1.2 Shutting down and switching off
Control software such as is typically used on Industrial PCs permits various users to be given different rights.
A user who is not permitted to close software may also not switch the Industrial PC off, as data can be lost
from the data storage device by switching off while software is running.
NOTE
First shut down, then switch off!
If the Industrial PC is switched off while the software is writing a file to the data storage device, this file will
be destroyed. Control software usually writes data to the data storage device automatically at intervals of a
few seconds, for which reason there is a very high probability of causing damage by switching off while
software is running.
NOTE
Switching off the Industrial PC
Once you have shut down the Industrial PC, you must switch it off for at least 10 seconds in order to be
able to restart it! After switching on the power supply again the Industrial PC starts automatically.
5.2 Operation
The Control Panel is operated via the touch screen.
NOTE
Damage to the touch screen
The touch screen may only be operated with your finger or the touch screen pen. The operator may wear
gloves but there must be no hard particles such as metal shavings, glass splinters embedded in the glove.
.
5.3 Maintenance
5.3.1 Cleaning
The device can be cleaned with a damp, soft cloth. Do not use any aggressive cleaning materials, thinners,
scouring material or hard objects that could cause scratches.
5.3.2 Maintenance
The Control Panel needs no maintenance.