Beckhoff C6032, Руководство пользователя

Страница: 43 / 53

Maintenance
C6032 43 Version: 2.0
To dispose of the battery, remove it, tape off the poles and put it in the battery disposal.
7.2.2 Replacing the storage media
New storage media should only be obtained from Beckhoff Service (see Chapter 10.1 Service and support).
The C6032 contains one or two M.2 SSDs.
Data transfer before replacement
If you want to exchange the SSD as recommended by Beckhoff, you must copy the data from the old to the
new SSD. You can use the Beckhoff Service Tool (BST) for this purpose. The BST is a graphical backup and
restore program for Industrial PCs with a Windows operating system. You can create an image of your
operating system and use it to back up the operating system. You can then restore the images created in
this way. You will receive the BST on a BST stick. For more information on the function of the BST, please
refer to the corresponding documentation.
If your SSD is defective and no backup copy of the data is available, Beckhoff Service will provide you with a
fresh Windows image. In this case the applications must be reinstalled.
If you have mirrored two SSDs in a RAID configuration and one of them has failed, you must first identify the
faulty disk. You can check in the runtime of your operating system which SSD you have to replace, SATA 0
or SATA 1. Fig. 30 shows the position of SATA 0 and SATA 1 in the Industrial PC. Please note the following:
• For the generation C6032-0060, diagram A in the figure applies.
• For the generation C6032-0070, diagram B in the figure applies.
SATA 0 SATA 1 SATA 1 SATA 0
A B
Fig. 30: C6032_SATA assignment
Replacing the storage media
Chapter 7.2 Maintenance [
}
40] shows how to access the storage media.
To change the storage media, follow the steps shown in Fig. 31:
1. Remove the Torx TX10 fastening screw and the SW5 bolt of the storage medium you want to remove
(section A).
ð
The storage medium automatically places itself in an inclined position (section B).
2. Pull the storage medium out of the slot in the inclined position (section C).