Beckhoff AX2500 Series, Сборка, установка, настройка

Страница: 67 / 81

5.5 Warning messages
Faults which occur, but which do not cause a switch-off of the amplifier output stage
(BTB/RTO contact remains closed), are indicated in the LED display on the front panel by
a coded warning number.
Number Designation Explanation
A/I/P/E Status message status message, no error, see page 65
. . .
Status Message amplifier is updating the startup configuration
n01 I²t I²t threshold exceeded
n02 regen power reached preset regen power limit
n03* S_fault exceeded preset following error limit
n04* response monitoring
response monitoring (fieldbus) has been
activated
n05 supply phase supply phase missing
n06* Sw limit-switch 1 passed software limit-switch 1
n07* Sw limit-switch 2 passed software limit-switch 2
n08 motion task error a faulty motion task was started
n09
no reference point no reference point set at start of motion task
n10* PSTOP PSTOP limit-switch activated
n11* NSTOP NSTOP limit-switch activated
n12 default values
only for HIPERFACE
®
:
motor default values loaded
n13*
expansion card expansion card not operating correctly
n14 SinCos feedback SinCos commutation failure
n15 table fault fault as per speed/current table INXMODE 35
n16
Summarized warning Summarized warning for n17 to n31
n17 Fieldbus-Sync Fieldbus not synchronized
n18 Multiturn overflow Max. number of motor turns exceeded
n19-n31 reserve reserve
n32 firmware beta version firmware version has not been released
* = these warning messages result in a controller shut-down of the drive (braking by
emergency stop ramp)
AX2500 Installation Manual 67
Beckhoff
02/06
Setup