Becker P5-20-C18 PLUS, Руководство по сборке и эксплуатации

Страница: 18 / 36

Deleting both limit positions
Any additional functions that may have been set are deleted at the same time, or are reset
to the factory default settings.
Select the required receiver as described in the chapter Selection of the receiver for
the setting mode [
}
13].
Open/close the shading solution to a point between the limit positions.
3s
Press the programming button and, within the next 3 seconds, press the STOP button
at the same time and hold the two buttons down for 3 seconds.
▻ The tubular drive confirms.
▻ The transmitter confirms.
► The limit positions are now deleted.
3s
Then press the programming button for 3 seconds to change to normal mode.
► The LED ring goes out.
Intermediate positions I + II
The intermediate positions I + II are freely selectable positions for the shading solution
between the two limit positions. Each travel button can be assigned one intermediate posi-
tion. Both limit positions must be set before an intermediate position is set.
Setting/modifying the desired intermediate position
Open/close the shading solution to the desired intermediate position.
or
Press the STOP button and, within 3 seconds, also press the desired travel button
and hold the two buttons down.
▻ The receiver confirms.
▻ The transmitter confirms by lighting up the upper/lower third of the LED ring
light blue.
►
The intermediate position is now saved.
If several receivers are operated on the same channel, a specific receiver can also be se-
lected beforehand. You can select the required receiver beforehand by following the de-
scription in the chapter Selection of the receiver for the setting mode [
}
13] .
Travelling to the desired intermediate position
2x
or
2x
Press the travel button for the desired intermediate position twice within one second.
▻ The transmitter confirms with a rotational movement of the LED ring from
blue to turquoise.
►
The shading solution travels to the intermediate position assigned to the travel
button.
18 - en