Becker P5-20-C18 PLUS, Руководство по сборке и эксплуатации

Страница: 17 / 36

2) Extending the range of travel (the desired limit position is located outside the current range of
travel)
Attention
When both or individual limit positions are deleted, all the other set functions (intermediate
position I, intermediate position II) are deleted as well.
Select the required receiver as described in the chapter Selection of the receiver for
the setting mode [
}
13].
Open/close to the limit position in the direction in which you wish to extend the range
of travel.
3s
Press the programming button and, within the next 3 seconds, press the STOP button
at the same time and hold the two buttons down for 3 seconds.
▻
The tubular drive confirms.
▻
The transmitter confirms with red pulsing of the LED ring.
►
The limit position is now deleted.
Open/close to the desired new limit position.
or
First press and hold the programming button, then within 3 seconds also press and
hold the button for the extend limit position, or the button for the retract limit pos-
ition. Hold the two buttons down.
▻
The tubular drive confirms.
▻
The transmitter confirms by lighting up the upper/lower third of the LED ring.
►
The new limit position is now saved.
3s
Then press the programming button for 3 seconds to change to normal mode.
► The LED ring goes out.
Deleting the limit positions
Attention
When both or individual limit positions are deleted, all the other set functions (intermediate
position I, intermediate position II) are deleted as well.
Deleting individual limit positions
Select the required receiver as described in the chapter Selection of the receiver for
the setting mode [
}
13].
Open/close to the limit position to be deleted.
3s
Press the programming button and, within the next 3 seconds, press the STOP button
at the same time and hold the two buttons down for 3 seconds.
▻
The tubular drive confirms.
▻
The transmitter confirms.
►
The limit position is now deleted.
3s
Then press the programming button for 3 seconds to change to normal mode.
► The LED ring goes out.
17 - en