Becker P5-20-C18 PLUS, Руководство по сборке и эксплуатации

Страница: 15 / 36

Intelligent installation management
Completion of installation following automatic setting of limit positions
The drive saves the limit position permanently once the upper limit position is reached 3 times in succession. Installation is then
complete. If the limit position is set above a point, this is stored permanently.
Limit position status indicator
A brief stopping and restarting indicates that no limit position has been set in that direction of movement.
Setting the limit positions
The running direction must be correct. When setting the limit positions, the tubular drive
runs in dead-man mode and limit position status indicator. The lower limit position must al-
ways be set first. If the tubular drive switches off prematurely while opening or closing,
due to an obstruction, the obstruction can be cleared by opening or closing the screen and
removing the obstruction. The desired limit position can be set by opening or closing
again.
There are several ways to set the limit positions:
•
Lower point to upper point
• Lower point to upper stop
• Auto install
The limit position becomes fixed after the tubular drive has turned off automatically in the desired position three times.
Lower point to upper point
There is no shading solution length adjustment with this limit position setting.
Select the required receiver as described in the chapter Selection of the receiver for
the setting mode [
}
13].
Close to the desired lower limit position.
Press the programming button and, within 3 seconds, also press the button and
hold the two buttons down.
▻ The tubular drive confirms.
▻ The transmitter confirms by lighting up the upper third of the LED ring.
Then open to the desired upper limit position.
Press the programming button and, within 3 seconds, also press the button and
hold the two buttons down.
▻ The tubular drive confirms.
▻ The transmitter confirms by lighting up the lower third of the LED ring green.
► The limit positions are now set.
3s
Then press the programming button for 3 seconds to change to normal mode.
► The LED ring goes out.
15 - en