Becker L120/11C PSF, Руководство по сборке и эксплуатации, Страница: 13 / 24

Changing direction of rotation via the master transmitter
It is only possible to change the direction of rotation if no limit position has been set.
Press the UP or DOWN button.
▻ The shading solution runs in the desired direction.
► The running direction is OK.
If the shading solution runs in the wrong direction, the running direction must be switched. Proceed as follows:
Press the programming button and, within the next 3 seconds, also press both the UP
and DOWN buttons. Hold down the buttons for 3 seconds.
► The tubular drive clicks 3 times to confirm.
Check the running direction again.
Setting the limit positions
The limit positions can only be set with the master transmitter. The shutter direction must
be correct. When setting the limit positions, the tubular drive runs in dead-man mode and
limit position status indicator. The extended limit position must always be set first. If the
tubular drive switches off prematurely while extending/retracting, due to an obstruction,
the obstruction can be cleared by extending/retracting the screen and removing the ob-
struction. The upper limit position can be set by extending/retracting again.
There are 2 ways to set the limit positions:
• Extended position to retracted position without stop
• Extended position to retracted stop
The limit position becomes fixed after the tubular drive has turned off automatically in the desired position three times.
Extended position to retracted position without stop
There is no curtain length adjustment with this limit position setting.
Open to the desired extended limit position.
Press the programming button and, within 3 seconds, also press the extend button
and hold the two buttons down.
▻ The tubular drive makes a “click” sound to confirm.
Then close to the desired retracted limit position.
Press the programming button and, within 3 seconds, also press the retract button
and hold the two buttons down.
▻
The tubular drive makes a “click” sound to confirm.
►
The limit positions are now set.
13