Deleting the travel path with a Centronic
transmitter
When the travel path is deleted, the set intermediate posi-
tions will be deleted as well.
Open/close the shading solution to a point
between the limit positions.
10s
First press the programming button and, within 1
second, press the STOP button at the same time
and hold both buttons down for 10 seconds.
▻
The receiver confirms.
►
The reference route is now deleted.
Intermediate positions I + II
The intermediate positions I + II are freely selectable posi-
tions for the shading solution between the two limit posi-
tions. Each travel button can be assigned one intermediate
position. The travel path must be set before an intermediate
position is set.
In venetian blind operation, the current slat tilt is saved as
well as the intermediate positions I + II. The saved tilt is ap-
plied when moving to the respective intermediate position.
Setting/modifying the desired intermediate position
Open/close the shading solution to the desired in-
termediate position.
or
Press the STOP button and, within 3 seconds, also
press the desired travel button and hold the two
buttons down.
▻
The receiver confirms.
►
The intermediate position is now saved.
38 - en
