Becker C16, Руководство по сборке и эксплуатации

Страница: 14 / 24

Intermediate position II in the up direction
The intermediate position II is any shading solution position of your choosing. It is not pos-
sible to set an intermediate position II in the area of the limit position. Both limit positions
must be set before the intermediate position II is set.
When both or individual limit positions are deleted, this set function is deleted as well.
Setting the intermediate position II
Travel the shading solution to the desired intermediate position II .
Press the STOP button and, within 3 seconds, also press the UP button and hold the
two buttons down.
▻ The tubular drive acknowledges.
► The intermediate position II is now saved.
Checking the intermediate position II
2x
Press the UP button twice within one second.
► The shading solution runs to the intermediate position II.
Deleting the intermediate position II
2x
Move the shading solution to the intermediate position II.
Press the STOP button and, within 3 seconds, also press the UP button and hold the
two buttons down.
▻ The tubular drive acknowledges.
► The intermediate position II is now deleted.
Programming additional transmitters
In addition to the master transmitter, up to 15 further transmitters can be programmed in
the tubular drive. Before programming a radio controlled Sun-Wind-Sensor, the limit posi-
tions must be programmed.
3s
Press the programming button of the master transmitter for 3 seconds.
▻ The tubular drive acknowledges.
3s
Now press the programming button of a new transmitter which has not yet been pro-
grammed in the tubular drive for 3 seconds. Doing so activates the programming
mode of the tubular drive for a new transmitter for 3 minutes.
▻
The tubular drive acknowledges.
3s
Now press the programming button of the new transmitter you wish to program again
for 3 seconds.
▻ The tubular drive acknowledges.
► The new transmitter has now been programmed.
14 - en